germoms.blogg.se - Altium measure distance

This includes clearance between 3D models used to define extruded or simple types of component bodies. The component clearance Circuit Board design rule specifies the minimum distance that components can be placed from each other. While other programs may include a tool to measure distance from one component body to another, Altium Designer 3D measurement can measure the distance from one object to another, from a single face to another single face, an object to the board, and even cross-probing of multiple measurement results.Īltium Designer includes extensive PCB design rule checking, including a component clearance rule that can be configured to keep your components from colliding or coming within a specified distance from each other on all three axes.

The Altium Designer 3D measurement tool also includes several other advanced features that separate it from other ECAD tools.

Measurements are made in accordance with current units of measurement - mils or mm - as defined through the Properties panel (when no object is currently selected).The Native 3D PCB editor gives the designer not only a highly realistic view of what the fully assembled board will look like, but also the ability to perform critical PCB design software tasks, such as 3D clearance checking, examining the location and presentation of text strings, inspecting each individual 3D layer within a single layer mode, and even performing measurements directly within 3D.

Change the Snap Grid (shortcut G) if you cannot accurately position the cursor at the required points.

Continue making further measurements, or right-click or press Esc to exit measurement mode.

Click OK to close the dialog and return to the workspace.

This lists the straight line distance between the chosen start and end points for the measurement, as well as the component X and Y distances. Click or press Enter to define the end point. As you do so, the Status Bar will reflect the straight line distance, as well as dx and dy values.

Move the cursor to the required measurement end point.

Position the cursor then click or press Enter to define this point.

You are prompted (via the Status Bar) to select the start point for the measurement.Choosing the Reports » Measure Distance command from the main menus.Īfter launching the command, the cursor changes to a cross-hair and you will enter measurement mode.This command can be accessed from the Schematic Editor by: This command is used to measure the distance between two points on a schematic document.